Filter
Top Products
15
Picture Menu Operation
C. TEMP The C. TEMP (Colour Temperature) control allows
you to change the White balance setting between
Standard, Warm and Cool.
Use the or buttons to switch between settings.
P-NR The P-NR (Picture Noise Reduction) system is
designed to reduce picture noise during poor quality
reception conditions. Pushing the left or right buttons
will change the setting between OFF, STRONG,
WEAK and AUTO.
Use the or buttons to switch between settings.
AI When the AI (Artificial Intelligence) is turned on it
continually and precisely detects fine differences in
the picture signal. It also detects the differences in
the brightness, black level and contrast levels.
Use the or buttons to switch the AI on or off.
SCAN MODE The SCAN MODE control allows you to change the
Picture refresh setting between AUTO, 100Hz
MODE and PROGRESSIVE.
Use the or buttons to switch between settings.
AUTO The TV software will select the best mode for the signal being
viewed.
100Hz MODE 100Hz will give a steady picture for most signals.
PROGRESSIVE Recommended when receiving NTSC signals.
NOTE: The scan mode function is not available when Picture in Picture is
being used.
Switching is also possible using the button on the remote control.
Note:
We recommend that you set the SCAN MODE to PROGRESSIVE when viewing a PAL 60 or NTSC
transmission. When viewing a PAL transmission (other than PAL 60) with the SCAN MODE set to
PROGRESSIVE, the screen will flicker. This is not a fault.
Normalisation
Pressing the Normal Button ( ) on the remote control, when the Picture Menu is displayed will return all
picture settings to the factory preset levels. This is called “Normalisation”.
Normalisation will not occur if the Picture Menu is not displayed when the Normal Button is pressed.
MENU DYNAMIC
CONTRAST
BRIGHTNESS
COLOUR
SHARPNESS
NTSC-TINT
C. TEMP
P-NR AUTO
PICTURE
MENU DYNAMIC
C. TEMP
STANDARD
P-NR AUTO
CONTRAST
BRIGHTNESS
COLOUR
SHARPNESS
NTSC-TINT
PICTURE
SCAN MODE AUTO
PICTURE
AI AUTO
PICTURE
AI AUTO
SCAN MODE AUTO