Panasonic TX-43P250X Projection Television User Manual


 
15
General Operation
N
?
LD/DVD
REC
-
VCR
STR HELP
DISC SIDE
A B
TV/AV
1 2 3
456
789
0
F.P.
INDEX HOLD
STILL
CH SEARCH
PICTURE
SOUND
SET UP
TV/TEXT
SURROUND
100Hz/
PROGRE
MULTI
PIP
Volume Adjustment
Volume Adjustment
TV/AV Mode Selection
Direct programme Number
VCR/LD/DVD Play
Coloured buttons used for
Multi Screen functions
(see page 36)
Teletext functions (see page 38)
AV selection (see page 15)
VCR/LD/DVD
Fast Forward/cue
VCR/LD/DVD Stop
VCR/LD/DVD Control
(see page 41)
Help (see page 16)
TEXT hold (see page 39)
/Still (see page 37)
TEXT Index (see page 40)
/Channel Search (see page 37)
Power (Stand-by) (see page 9)
Note:
It is also possible to turn the TV set on from
STANDBY mode by pressing the Direct
Programme Number Selection Buttons (0-9) and
the Programme Number Up or Down Button,
either on the set or on the Remote Control.
The TV set must first be plugged into the wall
outlet and turned on at the power switch.
Press this button to turn the TV set On from
Standby mode, Press it again to turn the TV
set OFF to Standby mode.
Sound Mute
Press to mute the sound completely the Mute symbol will appear.
Press again to restore the previous sound level, and cancel the mute.
Programme Number Selection
Press to select the next higher
or lower Programme number.
Press to increase or decrease
the sound volume level.
VOLUME 18
Press to select TV, AV1, AV2, AV3
and AV4 input signal modes
sequentially.
AV1 AV2 AV3 AV4
Remote control :
Press to display AV1 - AV4 at the
bottom of the screen. Each
coloured button corresponds to
each input signals. For example,
pressing the Red button selects
AV1.
TV/AV
Direct Programme Number
Selection (CH SELECT = DIRECT)
You can select the number directly by
pressing the corresponding programme
number buttons.
Programme Number 8.......
Programme Number 36..... ,
Programme Number 124... , ,
Direct Programme Number
Selection (CH SELECT = POSITION)
You can select the numbers directly by
pressing Number 0-9 buttons or by
pressing Two Digit and Number 0-9
buttons.
Programme Number 8 .....
Programme Number 12.... , ,
Note:
When the Skip setting for Programme
Number 100 through 125 is on, the
channel selection time will be
shortened, and thus you can not input
three digits at a time.
1
2
2
3
4
6
8
8
1
Volume Adjustment