Filter
Top Products
Cable binding instructions
Preventing the plasma display from failing over
Securing to a wall.
Notes:
• Securely attach to a wall, pillar or similarly solid
structural feature using separately- obtained
products such as cords or chains of adequate
strength.
• Secure in the wall at two locations each on the left
and right.
1 Attach the clampers to the pedestal.
Attach the stand clampers (right and left).
2 Connect the cable and mains lead.
3 Use the clampers to bind the cable and
mains lead.
The picture shown is illustrative purposely only and may differ slightly from the actual product.
* For cable connection, refer to the operating instructions of plasma display.
Mains lead
Clampers
Accessories for pedestal security
We recommend that measures are taken to prevent the Plasma display from falling over in such an event.
* The information in this section is designed to reduce the risk of injuries caused by the Plasma display falling over
during an earthquake, etc.
However, no measure can guarantee protection against all earthquakes.
5
English
How to
release:
How to fi x:
Push both side hooks
and pull out
Clampers