Filter
Top Products
14
Rear panel
<Fan
This fan is used to cool down the VTR.
If, for any reason, the fan stops, “E-10” will appear
on the counter display.
=SIGNAL GND terminal
This is connected to the signal ground terminal on
the component connected to this VTR in order to
minimize noise. It is not a safety ground.
>ANALOG COMPONENT VIDEO OUT connectors
The analog component video signals are output
through these connectors.
?ANALOG COMPOSITE VIDEO OUT connectors
The analog composite video signals are output
through these connectors.
The waveform monitor (WFM) signal can be output
from the VIDEO OUT 2 connector.
It can be selected using setup menu No. 00 (WFM
SEL).
Video signals containing superimposed information
can be output through the VIDEO OUT 3 connector.
Whether the superimposing is to be set ON or OFF
is selected using the SUPER switch W on the front
panel.
@RS-232C connector
A personal computer or other component can be
connected to this connector to operate the VTR.
Parts and their functions
APARALLEL REMOTE connector
This connector is used when the VTR is to be
operated by an external component.
BANALOG AUDIO OUT connectors
The analog audio signals are output through these
connectors.
CMONITOR OUT connectors
During playback, the PCM audio signals
(CH1/CH2/CH3/CH4) or playback signals from the
CUE track are output through these connectors.
<Note>
Noise may appear on the CUE signal at the instant
recording is started.
DSDTI input and output connectors (optional)
When the SDTI board (AJ-YAC930G, optional
accessory) is installed in this VTR, digital data can
be input and output using the SDTI (Serial Data
Transport Interface) format.
IEEE1394 digital input/output connector
(optional)
Use of an digital video interface board (AJ-
YAD955G, optional accessory) enables input/output
interfacing of the digital signals with the IEEE1394
standard.