Filter
Top Products
18
TITLE SETUP MENU
CH TITLE
1 1·······
2 2·······
3 3·······
4 4·······
5 5·······
6 6·······
7 7·······
8 8·······
9 9·······
2/2
TITLE SETUP 1/2
CH TITLE
1 1·······
2 2·······
3 3·······
4 4·······
5 5·······
6 6·······
7 7·······
8 8·······
2. Move the cursor to the title (TITLE) you want to edit.
3. Select the first character for the title by pressing the
Increment (+) or Decrement (–) button.
Characters for the title appear in the order shown
below.
ABCDEFGHIJKLM
NOPQRSTUVWXYZ
0123456789
←→
=?’”#&()
*
+,
-./:;
.
(space mark)
<WJ-FS316/FS416>
<WJ-FS309/FS409>
4. After selecting the first character, press the B button.
Then select the second character.
5. Repeat steps 3 to 4 above to complete the title.
6. Repeat steps 2 to 5 to edit the titles of other channels.
7. Press the MENU/ESC button to finalize the character
selection. The title is set, and the display returns to
SYSTEM SETUP.
To erase a specific character
1. Select a character to be erased.
2. Select “•” (space mark) to erase the character.
To erase the title of a specific channel
1. Move the cursor to the channel number whose title is to
be erased.
2. Press – and + buttons 2 seconds or more simultaneous-
ly.
3. Press the MENU/ESC button to execute the selection
and return to the SYSTEM SETUP menu.
3. CAM SW LOSS
This item lets you select whether to display “SW LOSS”
warning on the monitor when the camera switching pulse is
not supplied from the VCR.
Notes:
• This selection is effective only when the Recording
Mode in the Record Output Setup Menu is set to EXT.
• To reset the warning, reconnect the CAMERA SW IN
connector.
1. Move the cursor to the CAM SW LOSS parameter.
2. Select ON or OFF by pressing the + or – button.
The initial factory setting is ON.
ON: Enables the display (SW LOSS) on the monitor
screen.
OFF: Disables the display.
4. PLAYBACK AUTO
This item lets you enable or disable the PLAYBACK AUTO
mode. When PLAYBACK AUTO is set to ON, the pictures
displayed on the monitor correspond to the mode of the
VCR without the VCR/CAM button being pressed. Playback
pictures are displayed when the VCR is in playback mode
and camera pictures when the VCR is in non-playback
mode.
1. Move the cursor to the PLAYBACK AUTO parameter.
2. Select ON or OFF by pressing the + or – button.
The initial factory setting is ON.
2. TITLE POSI
This item lets you select the position on the monitor where
the camera title is displayed. The initial factory setting
places the title at the bottom center of the monitor screen.
1. Move the cursor to TITLE POSI parameter, then press
the SET button. The position setting menu appears on
the monitor screen.
2. Move the title by pressing the cursor (C, D, A, B) but-
tons.
CAMTITLE