Filter
Top Products
8 Operating Your Cleaner
Getting Ready
Step Action
1 Select your cleaning chemistry (check with your chemical
supplier for solution effects on metals).
2 Allowing for the volume of the parts you will be cleaning and
cleaning chemistry, fill the tank with warm tap water to the
operating level (one inch from the top).
3 Add cleaning chemistry to the tank water.
4 Plug the cleaner into a grounded outlet.
5 For maximum efficiency, refer to page 9, “Optimizing Your
Cleaner” before proceeding.
Cleaning Items
Step Action
1 Place the items to be cleaned into a basket or perforated tray.
2 If using a solid container, add cleaning solution to the container
to cover the items.
3 Slowly lower the tray into the tank. Do not allow items to
contact the tank bottom. Do not stir the solution.
4 When items are clean, slowly remove them from the cleaner.
5 Rinse the clean items with fresh water and dry them, if
necessary.
NOTE:
If this is the first time you are running the cleaner, or if you have changed
cleaning solution, you must degas the solution. This is done by setting
the cleaner up for operation and allowing the ultrasonics to drive the
warm solution for 5-10 minutes This will force out excess gas and assure
optimum cleaning. You will likely notice a change in the sound of the unit
as is degasses.