Filter
Top Products
5 of 9
ISSUED: 11-19-08 SHEET #: 120-9062-3 06-29-12
Visit the Peerless Web Site at www.peerless-av.com
For customer care call 1-800-865-2112.
• Always use an assistant or mechanical lifting equipment to safely lift and position the fl at panel screen.
• Do not tighten screws with excessive force. Overtightening can cause damage to mount. Tighten screws to 40 in. •
lb (4.5 N.M.) maximum torque.
• Be careful not to pinch fi ngers when pushing screen from the bottom.
WARNING
Installing Adapter Brackets
Adjust tension in tilt brackets by rotating ratchet handle.
NOTE: If obstruction prevents ratchet handle from rotating,
pull handle out while turning will allow handle to reposition
without tightening. Release and turn handle to tighten or
loosen.
Ratchet handle must be in the up or down position, or
interference will occur while hooking tilt brackets to wall
plate. Slowly hook tilt brackets onto wall plate and swing
screen down. Using 4 mm security allen wrench (I) turn
clockwise until screw fits firmly against wall plate to
prevent screen from being removed as shown in figure 3.3.
To remove screen from mount, loosen safety/security
screws, swing screen away from mount, and lift screen off
of mount.
fi g 3.2
SAFETY/
SECURITY
SCREW (L)
FLAT BRACKETS
TILT BRACKETS
WALL PLATE
WALL PLATE
SAFETY/
SECURITY
SCREW (L)
fi g 3.1
fi g 3.3
Hook flat brackets onto wall plate (not included). Then
slowly swing screen in as shown in figure 3.1. Using 4
mm security allen wrench (I) turn clockwise until screw
fits firmly against wall plate to prevent screen from
being removed. Screen can be adjusted horizontally by
loosening M5 x 25 mm screw (B) on flat brackets.
NOTE: To lock the screen down, tighten safety/security
screws (B) to wall plate as shown.
To remove screen from mount, loosen safety/security
screws, swing screen away from mount, and lift screen
off of mount.
3
3-1