Filter
Top Products
5 of 6
ISSUED: 10-30-10 SHEET #:125-9164-1
7
DISPLAY BASE
DRIED 3M RUBBER
AND VINYL #80 SPRAY
ADHESIVE (not supplied)
DESK SURFACE
NOTE: Display base may appear different
than illustrated.
A
G
Clean bottom of swivel plate assembly (A) with rubbing alcohol. Spray bottom of swivel plate assembly (A) only
where tape will be applied, with 3M rubber and vinyl #80 spray adhesive (not supplied). Wait at least 4 minutes
to dry before applying adhesive strip (G). Pull apart the four adhesive strips (G) and apply to bottom of swivel
plate assembly (A).
Clean desk surface with rubbing alcohol. Use 3M rubber and vinyl #80 spray adhesive (not supplied) on the
mounting surface area only. NOTE: Spray adhesive will not remove easily. Wait at least 4 minutes to dry before
removing red tape backing from adhesive strips (G) on swivel plate assembly (A). Place swivel plate assembly (A)
rmly on surface. NOTE: There is a recommended 72 hour cure time for tape on swivel plate assembly (A).
NOTE: Once tape backing is removed be careful not to touch the sticky surface of the tape with ngers, as this can
cause the tape to lose some of its holding power.
NOTE: After application of tape on swivel plate assembly (A), the bond strength will increase as the adhesive ows
onto the surface.
At room temperature, approximately 50%
of the ultimate strength will be achieved
after 20 minutes, 90% after 24 hours,
and 100% after 72 hours. In some cases,
bond strength can be achieved more quickly
by exposure to elevated temperatures
(e.g. 150°F [66°C] for 1 hour).
BOTTOM OF DISPLAY