Filter
Top Products
ISSUED: 09-04-08 SHEET #: 090-9150-3 10-05-09
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.
4 of 6
BOTTOM OF DESKTOP
4
D
B
FIG 4.1
C
B
TIGHTENING
SLOPE NUT
Hand tighten slope nut (D) through 1/4-20 x 1 3/4"
screw bolt (B) until snug against bottom of desktop
surface. Thread another slope nut (D) upside-down,
about two turns from first slope nut (D). Insert a open
box wrench between both slope nuts (D) and tighten.
NOTE: Avoid jamming both slope nuts (D) together,
doing so may make it difficult to remove slope nut
used for tightening first slope nut (D). After slope nut is
secure remove bottom slope nut and add plastic cap
(C) as shown in figure 4.2. Repeat with remaining
1/4-20 x 1 3/4" screw bolt (B).
FIG 4.2
RUBBER FEET
Attach lock-down plate to display base bottom using
screws provided by manufacturer. Refer to page three
for lock-down plate/ display base stand hole pattern.
NOTE: Remove existing rubber feet from display base
that interfere with the lock-down plate.
NOTE: Display base stand and mounting
hole locations may appear different than
illustrated.
DISPLAY BASE STAND
A
3
SCREWS SUPPLIED BY
MANUFACTURER