Peerless Industries HLG452-002 TV Mount User Manual


 
ISSUED: 09-04-08 SHEET #: 090-9150-3 10-05-09
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.
6 of 6
DRIED 3M
RUBBER AND
VINYL #80 SPRAY
ADHESIVE
CLEAN WITH
RUBBING
ALCOHOL
Clean bottom of lock-down plate (A) with rubbing alcohol. Spray bottom of lock-down plate (A) only where tape will
be applied, with 3M rubber and vinyl #80 spray adhesive. Pull apart the four adhesive strips (E) and remove red
backing film on both sides. Wait at least 4 minutes to dry before applying adhesive strip (E). Attach adhesive
strips (E) firmly to bottom of lock-down plate (A) as shown below.
4
E
A
Clean desk surface with rubbing alcohol. Use 3M rubber and vinyl #80 spray adhesive (not supplied) on the mounting
surface area only. NOTE: Spray adhesive will not remove easily. Wait at least 4 minutes to dry before removing tape
backing from lock-down plate (A) and placing firmly on surface. NOTE: There is a recommended 72 hour cure time for
tape on lock-down plate (A).
NOTE: Once tape backing is removed be careful not to touch the sticky surface of the tape with fingers, as this can
cause the tape to lose some of its holding power.
NOTE: After application of tape on lock-down plate (A), the bond strength will increase as the adhesive flows onto the
surface.
At room tempurature, approximately 50%
of the ultimate strength will be achieved
after 20 minutes, 90% after 24 hours,
and 100% after 72 hours. In some cases,
bond strength can be achieved more quickly
by exposure to elevated temperatures
(e.g. 150°F [66°C] for 1 hour).
DISPLAY BASE STAND
DRIED 3M RUBBER AND
VINYL #80 SPRAY
ADHESIVE (not supplied)
DESK SURFACE
NOTE: Display base stand may appear
different than illustrated.