Filter
Top Products
6 of 34
ISSUED: 11-09-07 SHEET #: 202-9251-4 04-12-10
Installing Adapter Brackets
To prevent scratching the screen, set a cloth on a fl at, level surface that will support the weight of the screen.
Place screen face side down. If screen has knobs on the back, remove them to allow the adapter brackets to be
attached. Place adapter brackets (BB) on back of screen, align to holes, and center on back of screen as shown
below. Attach the adapter brackets to the back of the screen using the appropriate combination of screws, wash-
ers and spacers as shown in fi gure 2.1 or 2.2.
NOTE: Top and bottom holes must always be used.
Verify that all holes are properly aligned, and then tighten screws using a phillips screwdriver.
BB
CENTER BRACKETS VERTICALLY
ON BACK OF SCREEN
X
X
• Tighten screws so adapter brackets are fi rmly attached. Do not tighten with excessive force. Overtightening can cause
stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become de-
tached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly se-
cured, damage may occur to screen or product may fail.
WARNING
NOTE: For fl at back screens proceed to step 2-1. For bump-out or recessed back screen skip to step 2-2.
NOTE: "X" dimensions should be equal.
2