Filter
Top Products
4 of 27
ISSUED: 05-17-07 SHEET #: 202-9208-3 5-7-08
Visit the Peerless Web Site at www.peerlessmounts.com
For customer care call 1-800-865-2112 or 708-865-8870.
Installation to Double Wood Stud Wall
1
NOTE: If mounting equipment weighing greater than 100 lbs, triple stud mounting is strongly recommended.
Skip to page 5.
Wall plate (A) can be mounted to two studs that are 16" apart. Use a stud finder to locate the edges of the studs.
Use of an edge-to-edge stud finder is highly recommended. Based on their edges, draw a vertical line down each
stud’s center. Place wall plate on wall as a template. The top mounting slots should be located above the desired
screen center as shown in figure 1.1. Note: Screen tilt will determine wall plate location. Level plate, and mark the
center of the two mounting holes. Make sure that the mounting holes are on the stud centerlines. Drill two 5/32"
(4 mm) dia. holes 2-1/2" (65 mm) deep. Make sure that the wall plate is level, secure it using two #14 x 2.5" wood
screws (C) as shown in figure 1.2.
Skip to step 2 on page 7.
• Installer must verify that the supporting surface will safely support the combined load of the equipment and all attached
hardware and components.
• Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder is
highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Installers
are responsible to provide hardware for other types of mounting situations.
WARNING
fig. 1.1
C
A
fig. 1.2
STUD
A
X
Tilt X Distance
0° 5.8" (147 mm)
2° 2.8" (71 mm)
5° 5.8" (147 mm)
10° 2.8" (71 mm)
CENTER OF
SCREEN
PFT640
WALLPLATE SHOWN