Filter
Top Products
4 Pelco Manual C1910M (3/98)
Power-Cord Protection
Power cords should be routed so that they are not likely to be walked on or pinched
by items placed upon or against them. When routing power cords, pay attention to
cords at plugs, convenience receptacles, and the point where they exit from the
monitor.
Overloading
Do not connect more power plugs to one outlet than it can safely handle. This may
overload wall outlets and extension cords and can result in a risk of fire or electric
shock.
Object and Liquid Entry
Never push objects of any kind through openings in this monitor as they may touch
dangerous voltage points or “short-out” electrical parts and could result in a fire or
electric shock. Never spill liquid of any kind on the monitor.
Servicing
Do not attempt to service this monitor yourself. Opening or removing covers may
expose you to dangerous voltages or other hazards. Refer all servicing to qualified
service personnel.
Damage Requiring Servicing
Unplug this monitor from the wall outlet and refer servicing to qualified service
personnel under the following conditions:
a. When the power cord or plug is damaged.
b. If liquid has been spilled or objects have fallen into the monitor.
c. If the monitor is not marked “Suitable for Wet Locations” and it has been ex-
posed to rain or water.
d. If the monitor does not operate normally by following the operating instruc-
tions, adjust only those controls that are covered by the operating instructions.
Improper adjustment of other controls may result in damage and may require
extensive work by a qualified technician to restore the monitor to its normal
operation.
e. If the monitor has been dropped or the cabinet has been damaged.
f. When the monitor exhibits a distinct change in performance - this indicates a
need for service.
Replacement Parts
When replacement parts are required, be sure the service technician has used
replacement parts specified by Pelco or have the same characteristics as the origi-
nal part. Improper substitutions may result in fire, electric shock, or other hazards.
Safety Checks
Upon completion of any service or repairs to this monitor, ask your service techni-
cian to perform safety checks to determine that the monitor is in proper operating
condition.
WARNING:
This prod-
uct has been evaluated
for INDOOR USE ONLY
unless it bears the mark-
ing “For Use in Wet Lo-
cations.”
WARNING:
To reduce
the risk of electric shock
hazard, do not remove
the monitor cover. This
monitor cannot be ser-
viced by the user and
must be sent to a quali-
fied service person for
repair.