Filter
Top Products
Pelco Manual C1910M (3/98) 7
3.0 INSTALLATION
3.1 MOUNTING
The monitor has rubber feet and may be placed on any horizontal surface, such as
a desk or table.
The monitor also may be installed in a 19-inch (48.26 cm) rack or on a wall, ceiling,
or pedestal mount. Follow the instructions that accompany the rack kit or mount.
3.2 CONNECTIONS
1. Connect a video cable from the video source to the BNC connector labeled
VIDEO IN on the rear panel of the monitor (refer to Figure 1). Refer to Table A
for the type of video coaxial cable to use.
2. When the video signal is looped through the monitor, connect a video cable
from the BNC connector labeled VIDEO OUT to the equipment which requires
a video signal input (refer to Figure 1).
3. Set the termination switch on the monitor to the 75-ohm or OPEN position
(refer to Figure 1).
4. Plug in the power cord.
Table A. Video Coaxial Cable Wiring Distances
Cable Type* Maximum Distance
RG59 750 ft (229 m)
RG6 1,000 ft (305 m)
RG11 1,500 ft (457 m)
*Minimum cable requirements:
75 ohms
All-copper center conductor
All-copper braided shield with 95-percent braid coverage