Filter
Top Products
C2928M-QS (7/05) 13
Using The Remote Control
Using the the remote control is the only way to access menu settings. There are no access controls on the display unit.
The remote control projects a series of IR (infrared) pulses to the PMCD750 display for control. Aim the remote control at a single display and
press MENU. The main menu should be visible if the lamp is on. Refer to Figure 11 for remote control buttons and their associated commands/
actions.
Figure 11.
Remote Control Layout
CURTAIN
TURNS THE CURTAIN PATTERN
ON AND OFF
OPENS THE NEXT MENU, CHANGES
THE VALUE OF A SELECTED ITEM, AND
NAVIGATES RIGHT IN MENUS AND
IMAGE POSITIONING
NAVIGATES DOWN IN MENUS
AND IMAGE POSITIONING
LEVEL
OPENS THE INPUT LEVELS MENU
FREQ/PHASE
OPENS THE PICTURE MENU
SETUP
PERFORMS USER-SELECTED
AUTO SETUP OPTIONS
SIZE/POS
SUCCESSIVELY OPENS THE
PICTURE POSITION, ZOOM
TOP & LEFT, AND ZOOM
BOTTOM & RIGHT MENUS
WITH EACH PRESS
MISC
SUCCESSIVELY OPENS THE
COLOR BALANCE, MISCELLANEOUS,
LAMP SETTINGS, SERIAL PORT
SETTINGS, AND AUTO SETUP MENUS
WITH EACH PRESS
ENTER
SELECTS THE HIGHLIGHTED ITEM
AND, IN SOME CASES, CHANGES
THE VALUE
ON
TURNS THE LAMP ON
SOURCE
CHANGES THE DISPLAYED INPUT
OFF
TURNS THE LAMP OFF
SAVE
SUCCESSIVELY OPENS THE RECALL
AND SAVE MENUS WITH EACH PRESS
MONITOR
SUCCESSIVELY OPENS THE
MENUS FOR DISPLAY STATUS,
SERIAL PORT STATUS (RS-232),
SERIAL PORT STATUS (RS-485),
AND TEST PATTERNS WITH
EACH PRESS
MENU
OPENS THE MAIN MENU
WALL
OPENS THE ASPECT
RATIO AND WALL MENU
PREV
SELECTS THE PREVIOUS MENU
NAVIGATES UP IN MENUS
AND IMAGE POSITIONING
OPENS THE PREVIOUS MENU, CHANGES
THE VALUE OF A SELECTED ITEM,
AND NAVIGATES LEFT IN MENUS AND
IMAGE POSITIONING