Filter
Top Products
C641M (11/03) 5
Figure 1. Rack Ear Installation
IMPORTANT: Slots and openings in the cabinet provide ventilation and prevent it from overheating. Do not block these
openings. Never place the DVR near or over a radiator or heat register. Do not place it in a built-in installation, such as a rack,
unless proper ventilation is provided or Pelco’s instructions have been followed.
MOUNTING
The DX7100 may be placed on a flat surface, such as a shelf, or it can be installed in a 19-inch (48.26 cm) equipment rack.
FLAT SURFACE MOUNTING
Before placing the unit on a flat surface, attach the rubber feet (supplied) to the bottom of the DVR. The unit may scratch the
surface if the rubber feet are not installed.
EQUIPMENT RACK MOUNTING
To install the unit in an equipment rack:
1. Attach the handles to the rack ears using the four flat head screws provided. Refer to Figure 1.
2. Remove the top screw and bottom screw from the left and right side of the DVR. Remove the side plates. Refer to Figure 1.
3. Use the screws removed from the sides of the DVR and attach the rack ears to the unit. Refer to Figure 1.
4. Use four of the supplied 10-32 x .75-inch black screws and finishing washers and mount the assembly to a 19-inch (48.26 cm)
rack or console. Installation of the assembly may require two persons. One rack unit (1.75 inches or 4.45 cm) of spacing
between units is recommended.
REMOVE
PLATE
INSTALL
RACK
EAR