Filter
Top Products
8 C623M-ADDEN (3/04)
NETWORK SOFTWARE CONFIGURATION
Using the TCP/IP protocol, up to five DX8000 Series DVRs can be networked together for remote viewing and management. In addition,
up to five simultaneous PC, web, and mobile clients can connect to each DVR. The DX8000 Series DVR supports both static IP
addressing and dynamic addressing through Dynamic Host Configuration Protocol (DHCP). Consult your network administrator for more
information regarding IP address configuration.
NOTE: The system must be turned on, connected to a network, and you must be logged in with either Power User or
Administrator access to configure network software settings.
IMPORTANT: You must reboot the DVR for any network configuration changes to take effect.
To begin the network setup process:
1. Click
.
2. Click .
3. Click the Network tab if it is not already visible.
4. Enter a new name for your DVR in the Site Name field. (Site names can be up to 30 characters in length. The default site name
is DX8000.)
5. Enter a unique system ID for your DVR in the System ID field. (System IDs must start with a letter, must be 15 characters or
less, and cannot include spaces or special characters.)
NOTE: Your DVR’s site name is used to identify your system to clients and other DX8000 servers. Your DVR’s system ID is
used to uniquely identify your system on a local area network (LAN). System IDs are required to prevent possible conflicts
with other network devices.
6. Proceed to the steps for setting up DHCP or Static IP addressing in the following sections.
SETTING THE SYSTEM LANGUAGE
CONFIGURING THE LANGUAGE SETTING OF THE DX8000
NOTE: This feature is unavailable in the current software release. It will be available in future releases.