Filter
Top Products
C288M-G (8/05) 5
Installation
IWM-BK AND IWM-GY
1. Determine the mounting location. If the mount is to be attached to a corner, parapet, or pole mount adapter, install the adapter plate (refer
to the instructions supplied with the adapter). If the mount is to be attached to a wall, use the base of the IWM mount as a template and
mark the four fastener positions on the mounting surface. Set the IWM mount to the side and prepare the holes for the fasteners.
2. Pull the wiring through the mount. Refer to Table A for the type of video coaxial cable to use. For 24 VAC power, refer to Table B to
determine the size of wire to use.
3. Attach the mount securely with four fasteners of appropriate length (fasteners are not provided). Use fasteners with a maximum diameter
of 3/8-inch (0.95 cm) (fasteners are not supplied). If you install the IWM outdoors, seal the fastener holes with an appropriate sealant to
prevent water damage. Apply the sealant between the mount and the mounting surface.
4. If using an NPT threaded pipe (not supplied), pull the wiring through the NPT pipe and the dome back box.
5. Attach the dome back box to the mount arm following the instructions in the dome manual.
6. Tighten the set screw on the mount.
7. Refer to the manual supplied with the Spectra dome system to complete the installation.
IWM24-BK AND IWM24-GY
PREPARE MOUNTING SURFACE
Determine the mounting location. If the mount is to be attached to a corner, parapet, or pole mount adapter, install the adapter plate (refer to the
instructions supplied with the adapter). If the mount is to be attached to a wall, use the base of the IWM mount as a template and mark the four
fastener positions on the mounting surface. Set the IWM24 mount to the side and prepare the holes for the fasteners.
PREPARE IWM24 MOUNT FOR INSTALLATION
1. Loosen the two Phillips pan-head screws, and remove the access plate from the bottom of the mount arm. Refer to Figure 1.
Figure 1.
IWM24 Series Mount
ACCESS PLATE
(IWM24-BK AND
IWM24-GY ONLY)
SET SCREW
3/4-INCH NPT PLUG