Pelco PMCL-CMP TV Mount User Manual


  Open as PDF
of 4
 
5. Hold the monitor level with the mounting head. Refer to one of the following and attach the monitor mount to the monitor.
• 31-inch monitor or smaller: Align the monitor to the correct hole pattern on the mounting plate. Use the M4 x 10 mm screws and split lock
washers (supplied) to secure the monitor to the mounting plate.
• Monitors larger than 31-inches: Align the monitor to the outside hole pattern of the monitor plate. Use the M6 x 12 mm screws and flat
washers (supplied) to secure the monitor to the mounting plate.
6. Power and video wires can be pulled through the center of the pole, or run along the outside of the pole.
7. Using the 3/16-inch Allen wrench (supplied), loosen the button head bolts on the side of the mounting head. Tilt the monitor to the desired angle.
To secure the monitor in place, retighten the button head bolts.
8. To swivel the monitor between portrait and landscape views, loosen the nut on the back side of the mounting head using a 9/16-inch wrench (not
supplied). Retighten the nut to secure the monitor in place.
3/16-INCH ALLEN WRENCH
BUTTON HEAD BOLTS
MOUNTING HEAD
10-32 SETSCREW (USE
3/32-INCH ALLEN WRENCH)
M4 X 10 MM SCREW
SPLIT LOCK WASHER
MOUNTING FLANGE
6-32 SETSCREW (USE
1/16-INCH ALLEN WRENCH)
10-32 SETSCREW (USE
3/32-INCH ALLEN WRENCH)
RETAINING RING
REVISION HISTORY
Manual # Date Comments
C2227M 8/06 Original version.
C2227M-A 11/06 Inserted statement per UL about minimum 2 x 4 wood beam.
C2227M-B 12/06 Added hardware information for large monitors per ECO 06-17078.
C2227M-C 4/07 Updated description to include PMCL-VA.
C2227M-D 8/07 Added instructions for concrete ceiling. Removed 1/16-inch Allen wrench and 6-32 setscrew. Added information about PMC-V100 adapter.
Pelco, the Pelco logo, Camclosure, Esprit, ExSite, Genex, Legacy, and Spectra are registered trademarks of Pelco. ©Copyright 2007, Pelco. All rights reserved.
Endura, and Spectra III are trademarks of Pelco.
DLP is a registered trademark of Texas Instruments Incorporated
The materials used in the manufacture of this document and its components are compliant to the requirements of Directive 2002/95/EC.
Figure 4. Mounting a Monitor Using PMCL-CMP
 previous