Filter
Top Products
Fast Ethernet Media Converter – Installation Guide
3
Installation
The default switch settings (all switches in the UP position) will work
for most installations.
There are five steps required to configure the Perle Fast Ethernet
media converter:
1. Set the Auto-MDIX jumper setting (optional).
2. Set the switch settings (optional).
3. Install and connect the fiber cable.
4. Install and connect the copper cable.
5. Power up the media converter.
Auto MDIX Jumper Settings
Note: The factory settings for Auto-MDIX will work for most
installations, but in the rare case that you need to modify the settings,
the procedure is below.
To access the Auto-MDIX jumper settings, unscrew the four side
screws on the top case and remove the cover plate. Locate the MDIX
AUTO jumper set as detailed below. By covering or strapping pins 1
and 2, the S-100 will operate as an MDIX device. By covering or
strapping pins 2 and 3, the S-100 will automatically detect the
Ethernet cable’s polarity. Removing the strapping is the same as
AUTO.
NOTE: The default jumper setting is Auto