Philips 14PV374 TV VCR Combo User Manual


 
17
EN
9. Before you call an engineer
Your TV-Video Combi does not respond to
any button being pressed:
*There is no power supply: check the power
supply.
*Parental control is on:switch the parental con-
trol off.
*There is a technical problem: disconnect from
the mains power supply for 5 minutes, then
power-up again.
If this doesn't help, you can reset your TV-Video
Combi to the default factory settings.
Resetting devices to default factory settings
*Warning: All the information stored (TV chan-
nels, time and date, TIMER) will be cleared.
1.Switch the TV-Video Combi to stand-by.
2.Press and hold and at the
same time for 2 seconds or more.
A cassette is jammed in the TV-Video Combi
*Don’t use force. Disconnect the set from the
mains and reconnect it again after a few sec-
onds.
Remote control does not work
*Remote control is not pointed at the TV-Video
Combi.
*Take out the batteries, wait for 10 seconds and
place them back in the remote control.
*Batteries have run out. Change the batteries.
No picture when you play a cassette
*There is no recording on the cassette.
Poor picture quality when you play a cas-
sette
*The cassette is badly worn-out or of poor qual-
ity. Use a new cassette.
*Tracking is not properly adjusted.Turn to sec-
tion ‘Manual Tracking’.
*Magnetism from nearby appliances and geo-
magnetism might affect the colour of the TV
picture. Move the TV-Video combi away from
such sources.The TV-Video combi will readjust
itself automatically. If you want to initiate an
immediate readjustment, unplug the TV-Video
combi from the mains and plug it in again
approximately 30 minutes later.
PROG P-
REC I
No recording possible
*The TV channel you want to record is not
stored or you have selected the wrong pro-
gramme number: check TV channels stored.
*A cassette was inserted that does not have the
security tab (cannot be used to record): Insert
a cassette with an intact security tab or
change cassette. For more information, please
see the section ‘Preventing accidental erasing’
in chapter ‘Manual Recording’.
*’VPS/PDC’ switched on but ‘VPS/PDC time’
wrong: enter ‘VPS/PDC time’ exactly to the
minute. Check your aerial connection.
The wrong TV channel has been recorded
after you programmed a recording using the
S
HOWVIEW system
1.Enter the S
HOWVIEW programming number
you wanted to record.
2.Confirm with .
3.Check the programme number/channel name
in the ‘PROG.’ input field.
4.If this does not correspond to the desired TV
channel, select the input field and change
the programme number/channel name.
5.Confirm with .
Smart Clock does not work
*You have stored on programme number ‘P01’ a
TV channel that does not transmit TELETEXT.
Store on ‘P01’ a TV channel that transmits
TELETEXT.
*Poor TELETEXT reception. Store a TV channel
on ‘P01’ with good TELETEXT reception.
*You have not activated the Smart Clock func-
tion. Switch the function ‘ON’.
You can also call the customer service centre
in your country.The telephone numbers can be
found on the back of this instruction manual.
Have the model number (MODEL NO) and the
production number (PROD.NO.) of your
TV-
Video Combi ready.
FWD 1- B
FWD 1- B
If, contrary to expectation, you have any prob-
lems using this TV-Video Combi, it may be
caused one of the following reasons.
T6400EZ-BG/DK(EN).qx3 03.4.21 15:51 Page 17