Filter
Top Products
19EN
English
Computer connection issues
The computer display on the monitor is not
stable:
• Check that a supported resolution and
refresh rate is selected on the computer.
• Set the monitor picture format to
unscaled.
Contact us
If you cannot resolve your problem, refer to
the FAQs for this monitor at www.philips.com/
support.
If the problem remains unresolved, contact
Philips Consumer Care in your country as
listed in this User Manual.
Warning
• Do not attempt to repair the monitor yourself.
This may cause severe injury, irreparable
damage to your monitor or void your warranty.
Note
• Make a note of your monitor model and serial
number before you contact Philips. These
numbers are printed on the back of the
monitor and on the packaging.
Sound issues
There is a picture but no sound from the
monitor:
Note
• If no audio signal is detected, the monitor
automatically switches the audio output off —
this does not indicate malfunction.
• Check that all cables are properly
connected.
• Check that the volume is not set to 0.
• Check that the sound is not muted.
There is a picture but the sound quality is
poor:
• Check that the sound settings are
correctly set.
There is a picture but sound comes from one
speaker only:
• Verify that sound balance is set to the
center.
HDMI connection issues
There are problems with HDMI devices:
• Note that HDCP support can delay
the time taken for a monitor to display
content from an HDMI device.
• If the monitor does not recognise the
HDMI device and no picture is displayed,
try switching the source from one device
to another and back again.
• If there are intermittent sound
disruptions, check that output settings
from the HDMI device are correct.
• If an HDMI-to-DVI adaptor or HDMI
to DVI cable is used, check that an
additional audio cable is possible could be
connected to PC AUDIO IN (mini-jack
only).