Filter
Top Products
6
This function (only available on certain models) allows you to lock the set in order
to limit its use completely or partially.
Key lock
æ Press , select TV LOCK ( ) and press .
 Set the LOCK to ON.The keys are locked.
ê Switch off the set and put the remote control out of sight.The set cannot be
used (it can only be switched on using the remote control).
To cancel: switch LOCK to OFF.
Programme lock
æ Press ,select TV LOCK ( ) and press .
 Select PARENTAL CONT. and press .
ê Enter your confidential access code.The first time, enter the code 0711 then
confirm by re-entering 0711.The menu appears.
® Select PROGRAM NO. and use keys or to to enter the number
of the programme or socket you wish to lock.
To lock all of them, select ALL.
† Select LOCK then YES.
Ú Repeat stages ® and † for each programme to be locked.You can lock 5
programmes separately.
º P r ess to exit.To watch a programme which has been locked you will now
need to enter the confidential code;otherwise the screen will remain blank.
When a locked programme is displayed, use the P keys to access other
programmes (the keys are used to enter the code). Caution: in the case of
encrypted programmes which use an external decoder, it is necessary to lock the
corresponding EXT socket (and not the programme number).
To unlock all programmes
Repeat stages æ - ê above, then:
® Select CLEAR ALL and press .All programmes are unlocked.
To change the confidential code
Repeat stages æ - ê above, then:
® Select CHANGE CODE and enter your own 4-digit number.
† Confirm by entering it again.Your new code will be stored.
If you have forgotten your confidential code, enter the universal code 0711 twice.
To exit: press .
This function (only available on certain models) allows you to use your TV as an
alarm clock.
æ Press , select TIMER ( ) and press .
 The SET CLOCK menu appears. Enter the time ( or ).
Important: the time is updated automatically each time the set is switched on
using teletext information taken from programme 1. If programme 1 does not
have teletext, the update will not take place.
ê Select TIMER ACTIVE and press to switch the timer on or off.
® Select PROGRAM NO. and enter the number of the programme required.
† Select START TIME and enter the time at which the set is to switch on.
Ú Press to put the set into standby mode.It will switch on automatically at
the programmed time. If you leave the set switched on, it will merely change
programmes at the set time.
The set switches off automatically after 4 hours if no further commands are given.
Locking the set
Timer function