Filter
Top Products
- 8 -
In this sub menu, the Control settings of the TV can be configured.
In this sub menu, the Close Caption and V-Chip settings of the TV can be configured.
• ESP: Energy Saving Programmability Mode
(ESP) controls the maximum continuous viewing
time allowed by the control system. The ESP
Menu function is shown as "ESP", and its valid
values are OFF and 1 - 99 (in hours).
• Audio/Video Mute: The Audio/Video Mute
menu function determines whether the video
should be blanked and the audio muted, if the
currently tuned channel has no signal.
• Digit Timeout: This is the time-out to enter the
second digit of channel number (example: for
channel number 10 and above).
• Save CC: This menu item provides the option of
saving the Close Caption selection when the
television is switched OFF is “Yes” is selected..
• CC: This menu item allows selection of Close
Caption channels, or to turn Close Caption
“OFF”.
• Saved V-Chip: This menu item provides the
option of saving the V-Chip selection when the
television is switched OFF is “Yes” is selected.
•
V-Chip Menu Item: This menu item sets the
option of toggling the V-Chip Menu Item to
“Yes” or “No”.
• V-Chip Setup: This sub-menu allows the setting
and disabling of Movie and TV ratings for the V-
Chip.
• 3 Digit Entry: To allow for 3-digit entry of channel numbers via the Remote Control, select “YES”. Select
“NO” to allow only 2-digit entry of channel numbers via Remote Control.
• Source Menu Item: Toggle between “YES/NO” to enable or disable selection of the TV Source Input via the
guest Setup menu when using the guest Remote Control.
• Channel Guide: Select “YES” to allow the Channel Guide Menu to be displayed if the “Channel Guide” button
is pressed on the guest Remote Control. Select “NO” to disable this feature.
• Min Volume: This item sets the limit for minimum volume allowed for the television set. Use the Right/Left
cursor buttons or direct digit entry to adjust.
• Max Volume: This item sets the limit for the maximum volume allowed for the television set. Use the
Right/Left cursor buttons or direct digit entry to adjust.