Filter
Top Products
28 EN
PBS settings
[PBS mode]
Enables / disables the Professional mode.
[On]: • All settings in the Professional
mode Setup menu are in effect.
[Off]: • The TV operates as a normal
(consumer) TV.
[Application]
1 When application is [Hospitality], the
following are activated.
Last status is disabled.•
Limited Consumer menu: When •
in Professional mode, the guest can
display the Consumer menu to adjust
TV parameters. However, these
settings will not be stored in TV
memory.
TV lock and parental ratings (except •
Sleep timer) are disabled.
Entry into service mode is disabled •
in order to prevent the guest from
changing service settings.
2 When application is [Signage], the below
functions behave as per normal consumer.
Last status is enabled.•
The full TV menu can be accessed and •
changes are stored in TV memory.
TV lock and parental ratings are •
enabled.
Entry into service mode is enabled.•
Note
• The default application for TV should be
[Hospitality], while that for monitor should
be [Signage].
[Consumer setup]
A shortcut to enter the full TV menu. This
allows the installers to do all the TV setup
settings.
Note
Selects • [PBS settings] > [Store] to save
the changes in the [Consumer setup
menu].
[Smartloader / USB to TV]
Loads the TV conguration data (including the
video, audio, channel Table, and Professional
mode settings) from a Smartloader / USB device
to the TV set.
[TV to Smartloader / USB]
Loads the TV conguration data (including the
video, audio, channel Table, and Professional mode
settings) from the TV set to a Smartloader /USB
device.
[Store]
Selects [Conrm] to store Professional mode
settings.
Note
After storing the settings, refer to page 29
“Low power standby (Green / Fast)”:
When • [Fast] is selected, you need to
restart the TV mains power for the
changes in Professional mode to take
effect.
When • [Green] is selected, you need to
switch the TV from standby to on again
for the changes in Professional mode to
take effect.
[Reset]
Selects [Yes] to reset all settings in Professional
mode to factory default.
Switch on settings
[Maximum volume]
This option species the maximum allowable
volume level of the TV.
[Switch on picture format]
Sets available picture format when the TV is
switched on.
Note
If the picture format is not supported •
with the activated source, [Auto format]
detection is applied.