Filter
Top Products
10
01 32HFL5561D/27
02 SV1A0707100003
03 IC7U1 - 0 .11/M3.22
04 LC72HUL1 - 0.13
05 OPT (30) 22 20 1C 23
06 OPT - MODEL 32HFL5561D/27
07
08 COMMUNICATION SP - SPI ONLINE
01 TV2 NOT TUNED
01 32HFL5561D/27
02 SV1A0707100003
03 IC7U1 - 0 .11/M3.22
04 LC72HUL1 - 0.13
05 OPT (30) 22 20 1C 23
06 OPT - MODEL 32HFL5561D/27
07
08 COMMUNICATION SP - SPI ONLINE
01 TV2 NOT TUNED
8 Installation of Pay-Per-
View box
This section describes how to install an external pay-per-view box.
Step1: Set the communication mode
You must setup the correct communication protocol before you
connect the Pay-Per-View box to the TV. This section describes how to
select the communication mode.
1 Press M on the setup remote control.
2 Press to select COMMUNICATION.
3 Press to enter the COMMUNICATION menu.
4 Press to select SP-SPI.
5 Press to select STORE.
6 Press to store your setting.
Step2: Connect the pay-per-view box
Note
• Turn off your TV before you connect the pay-per-view box.
1 Insert the RJ12 cable of the Pay-Per-View box into the DATA 1
(RJ12) connector of the TV.
2 Connect the other cables as directed by the Pay-Per-View
provider.
3 After completing the connections of the cables, turn on the TV.
4 Press RECALL on the setup remote control and check that the
status of SP-SPI is ONLINE. If the status is OFFLINE, check that
the RJ12 cable and the connections between the terminal and
the TV are correct.
STORE >
COMMUNICATION
COMMUNICATION
SP-SPI
DCM TYPE
CP
NO SOURCE SWITCH
NO
EN