Filter
Top Products
25
Access decoder channel
You can map channels provided through a
decoder or descrambler to your TV channel
selection. In this way, you can select these
channels by using the RC of your TV. The
decoder or a descrambler must be connected
to EXT1 (SCART).
Set decoder channel
Map channels from a decoder or descrambler.
1 Press MENU.
2 Select [Setup] > [Installation] >
[Decoder].
3 Press to enter [Decoder] menu.
4 Press to select [Channel], then press
to enter.
5 Select one channel to map to the
decoder / descrambler channel and press
OK to confirm.
6 Select [Status], then press to enter.
7 Select [EXT 1] (SCART) the connector
used by the decoder / descrambler.
8 Press OK.
9 Press MENU to exit.
Note
Select • [None] if you do not want to map to
the decoder / descrambler channel.
Change TV preferences
Use the preferences menu to customise your
TV settings.
1 Press MENU.
2 Select [Setup] > [Installation] >
[Preferences].
• [Location]: Optimises TV settings for
your location - home or shop.
• [Volume bar]: Displays the volume
bar when you adjust the volume.
• [Channel Information]: Displays
information about the TV channel
every time you switch channels.
Select [Full] to view channel
information or [Off] to turn off the
channel information.
• [Universal access]: Enables or
disables the universal access menu.
• [EasyLink]: Enables one-touch play
and one-touch standby between
EasyLink-compliant devices.
• [Pixel Plus Link]: Overrides the
settings of connected devices and
uses the settings of the TV. (Available
only when you activate Easylink).
• [E-sticker]: For shop mode only. Sets
the location of the e-sticker.
3 Press to select your preference.
4 Press OK.
5 Press MENU to exit.
English
EN