Filter
Top Products
If you want to change the DVB setting to start a new channel
installation, press h > Setup > Channel settings and press OK.
Select Channel installation > Antenna or Cable DVB and press
OK. Select the DVB setting you want.
DVB-C channel installation
For ease of use, all DVB-C settings are set to automatic. If your
DVB-C provider gave you specific DVB-C values, like a symbol
rate or a frequency, enter these values when the TV asks for
them during installation.
DVB-T + DVB-C
You can set up your TV for DVB-T and DVB-C. Install one
system followed by the other. When both installations are
complete, the Channel list will show both DVB-T and DVB-C
channels.
Reception quality
If you receive digital channels, you can check the quality and
signal strength of a channel.
If you use an antenna, you can reposition the antenna to try and
improve the reception.
To check the reception quality of a digital channel, switch to the
channel and press h > Setup > Channel settings and press
OK. Select Channel installation > Digital : reception test and
press OK.
The digital frequency is shown for this channel. If the reception is
poor, you can reposition your antenna. To check the signal
quality of this frequency again, select Search and press OK.
To enter a specific digital frequency yourself, select the frequency,
position the arrows on a number with x and w and change the
number with u and v. To check the frequency, select Search
and press OK.
If you use DVB-C to receive channels, the options Symbol rate
mode and Symbol rate are available. For Symbol rate mode,
select Automatic, unless your cable provider gave you a specific
symbol rate value. To enter the symbol rate value, use the
number keys.
Manual installation — Analogue
Analogue TV channels can be manually tuned in channel by
channel.
To install analogue channels manually, press h > Setup >
Channel settings and press OK. Select Channel installation >
Analogue : manual installation and press OK.
1 System
To set up the TV system, select System and press OK. Select
your country or part of the world where you are now.
2 Find channel
To find a channel, select Find channel and press OK. Select
Search and press OK. You can also enter a frequency yourself. If
the reception is poor, press Search again. If you want to store
the channel, select Done and press OK.
3 Fine tune
To fine tune a channel, select Fine tune and press OK. You can
fine tune the channel with u or v. If you want to store the
channel found, select Done and press OK.
4 Store
You can store the channel on the current channel number or as
a new channel number. Select Store current channel or Store as
new channel.
You can redo these steps until you found all available analogue
TV channels.
Clock settings
In some countries, digital broadcasts do not send UTC -
Coordinated Universal Time information. The daylight saving
change might be ignored and the TV might show an incorrect
time.
To correct the TV clock, press h > Setup > TV settings >
Preferences > Clock and select Country dependent. Select
Daylight saving and select the appropriate setting.
To set the time and date manually, select Manual. Then select
Time or Date.
Setup / Channels 45
Downloaded From TV-Manual.com Manuals