Filter
Top Products
12
6 Once connected, an IP address is obtained
automatically.
If no IP address is obtained, select •
[Retry] and press OK to try to obtain
the IP address again.
7 Select [Finish] in the menu, then press OK to
exit.
Note
This product does not support automatic detection of an •
Ethernet crossover cable.
Loading BD-Live content from the internet may take
•
some time, depending on the file size and the speed of
the internet connection.
Use Philips EasyLink
This product supports Philips EasyLink which uses the
HDMI CEC (Consumer Electronics Control) protocol.
You can use one single remote control to control
EasyLink-compliant devices that are connected
through HDMI connectors.
Note
To enable the EasyLink feature, you must turn on the •
HDMI CEC operations on the TV and on other devices
connected to TV. Refer to the TVs/devices manual for
details.
One-touch play
1
Press the STANDBY button to turn on this
product.
The TV (if supports one-touch play) »
automatically turns on and switches to the
correct video-in channel.
If a disc is loaded in this product, disc play »
automatically starts.
One-touch standby
1
Press and hold the STANDBY button for
more than 3 seconds.
All the connected devices (if the device »
supports one-touch standby) automatically
switch to standby.
Note
Philips does not guarantee 100% interoperability with all •
HDMI CEC devices.
Select menu display language
Note
If this product is connected to a HDMI CEC compliant •
TV, skip this setting. It switches automatically to the
same OSD menu language as per your TV setting (if the
language set on TV is supported by this product).
1 In the Home menu, select [Settings] and press
OK.
2 Select [Preference Setup], then press .
3 Select [Menu Language], then press .
The language options may vary from •
different regions.
4 Press to select a language, then press OK.
Setup network
To enjoy software updates of this product and BD-
Live bonus contents for certain Blu-ray discs, set up
the network connection.
Note
Ensure that the network cable is properly connected and •
the router is switched on.
1 Connect this product to the broadband
modem or router.
2 In the Home menu, select [Settings] and press
OK.
3 Select [Advanced Setup], then press .
4 Select [Network], then press OK.
5 Select [Next] in the menu, then press OK.
This product starts to detect if there is a »
connection to the network.
If the connection test fails, select » [Retry]
and press OK to re-connect again to the
network.
EN