Filter
Top Products
• If the channel you select has no
broadcast, the screen will be solid
blue.
• You cannot view closed captions
during recording or tape playback if
COUNTER ONLY is selected at step
4. Details are on pages 38 - 39.
Helpful Hints
1
Press the MENU button.
Function
Button
Pressed
Time
Channel
Counter
and
Counter
Memory
Tape
Speed
12:00 AM STOP
CH10
SLP M 1:23:45
A status display, which includes the current time, channel, and
other information (see illustration of the status display at right),
will appear when you press the STATUS/EXIT button or certain
function buttons. You can bring up the status display at any time
by pressing the STATUS/EXIT button. Remove the status display
by pressing this button again. The contents of the status display
may vary.
ON MODE:
● Whenever a function button (REW(ind)/s, PLAY/▲, etc.) is
pressed, the status display will appear for five seconds.
COUNTER ONLY MODE:
● When a function button (REW(ind)/s, PLAY/▲, etc.) is
pressed, the status display will appear for five seconds. After five
seconds, only the counter will remain on-screen. To remove it,
choose ON or OFF in the ON-SCREEN MODE menu. (There
is an exception. When you press the STOP/▼ button, the sta-
tus display will appear for five seconds, then disappear.)
OFF MODE:
● The status display will not appear when you press a function
button. The channel number will appear briefly when you select
a channel if channels are programmed.
To choose an ON-SCREEN MODE, follow the steps below.
2
Press the PLAY/▲ button or the STOP/▼ button to select
VCR SETUP. Then, press the F.FWD/B button.
3
Press the Number 3 button to select ON-SCREEN
MODE.
26 On-Screen Status Displays
4
Press the Number 1 button to select ON, the Number 2
button to select COUNTER ONLY, or the Number 3 but-
ton to select OFF. Your selection will appear on-screen.
5
Press the STATUS/EXIT button.
CCZ092comb.QX33 4/5/99 6:06 PM Page 26