Filter
Top Products
Triggers and alarms
Philips Communication, Security & Imaging 17
English
Alarm inputs
If an input causes an alarm
• Monitors A and B can switch to a pre-programmed view mode.
• Monitor A: The border around the displayed cameo is red. The alarm icon is
displayed in each cameo. An alarm status message is displayed.
• Monitor B: Sequenced display of pre-programmed cameras.
• The alarm beeper sounds. The alarm and the indicators flash.
• A controllable camera might be moved to a pre-defined position.
Acknowledging an input alarm
1.
Press the acknowledge key to acknowledge the alarm.
> The beeper is silent.
> The alarm and indicators are no longer lit.
> The alarm status message disappears.
> The last-used view mode is restored.
The alarm icon remains visible as long as the input causing the alarm is active.
If an alarm is not acknowledged, the beeper switches off after the dwell time but
the alarm still needs to be acknowledged.
If auto-acknowledge is enabled, the beeper, and the alarm and indicators
switch off after the dwell time.
Motion alarm
If a motion detection signal causes an alarm
• Monitors A and B can switch to a pre-programmed view mode.
• Monitor A: The border around the camera generating the motion signal is
yellow. The motion icon is displayed in the cameo. An alarm status message is
displayed.
• Monitor B: Sequenced display of pre-programmed cameras.
• The alarm beeper sounds. The motion and the indicators flash.
• A controllable camera might be moved to a pre-defined position.
Acknowledging a motion alarm
1.
Press the acknowledge key to acknowledge the alarm.
> The beeper is silent.
> The motion and indicators are no longer lit.
> The alarm status message disappears.
> The last-used view mode is restored.
The motion icon remains visible as long as the input causing the alarm is active.
If an alarm is not acknowledged, the beeper switches off after the dwell time but
the alarm still needs to be acknowledged.
If auto-acknowledge is enabled, the beeper, and the motion and
indicators switch off after the dwell time.
DVR16_LUI_DFUv1_1.book Page 17 Thursday, January 23, 2003 6:38 PM