Filter
Top Products
5
1.4 Programming the REO System monitor
No special programming is required for the REO Switcher. If using the REO Multiplexer, ensure that the Record mode is set to
Multiplexing (verify this via the REO Main Menu > Settings > VCR).
1.5 Programming the DVR1
To view the DVR1’s menu screen using the REO System Monitor:
• On the REO System Monitor, press MENU > SWITCH TO PLAYBACK VIEW
• On the DVR1:
Select MENU > ADVANCED MENU, then press ENTER
Enter the correct password (default is 0000) and ENTER
Press ENTER to access the Advanced Menu
Select MULTIPLEXER FORMAT, then ENTER
Select PHILIPS REO, then ENTER
Press MENU twice to exit.
1.6 Remote Viewing Considerations
The following pertains to the Remote Viewer Software (included with the DVR1; allows Remote Viewing of video via a PC with this
software loaded).
The Ethernet port connection depends on the network configuration:
• For a DVR1 connected directly to a Hub, use a Straight Through cable.
• For a DVR1 connected directly to a PC, use a Crossover cable.
• For a DVR1 connected via standard phone line (POTS) using LAN modems, refer to the Philips CSI Web site.
*
A PSTN-LAN
*
modem can be used for remote access to one of the Philips digital products through a POTS line.
*
Refer to our Web site at www.philipscsi.com under Tech Tips, #12 Applications Notes, 3COM OfficeConnect 56K LAN Modem.
Further information regarding connection of optional equipment is found in the DVR1 Instruction Manuals.