Filter
Top Products
34 Video Output, Video Mode
Video Mode
Just as you can adjust your picture on your TV, you can adjust some pic-
ture elements at the DVD Player. Choose a picture setting that best dis-
plays the Disc you are playing. This feature is known as Smart Picture or
Video Mode and can be adjusted by following the steps below.
1
Press SYSTEM MENU.
2
Press 9 repeatedly to select SETUP VIDEO OUTPUT,
then press OK.
3
Press 9 repeatedly to select VIDEO MODE, then press -.
4
Press 8 or 9 to select BRIGHT, STANDARD, SOFT, or
PERSONAL, then press OK. Continue to step 5 on page 35.
TV DISPLAY
VIDEO OUTPUT
TV TYPE
VIDEO MODE
F
BRIGHT
BRIGHTNESS STANDARD
CONTRAST SOFT
SATURATION PERSONAL
- - VIDEO OUTPUT PAGE - -
SET STANDARD VIDEO OUTPUT
2-4
Video Output
If you used S-Video or Component video connections as described on pages
11-12, set VIDEO OUTPUT to S-VIDEO or YCBCR (for Component Video)
by following the steps below. You only need one video connection between
the TV and the DVD Player. You can not use S-Video and Component Video
at the same time.
If you used the yellow VIDEO (VIDEO OUT) jack on the Player to connect
the Player to the TV, you do not need to adjust the VIDEO OUTPUT setting.
1
Press SYSTEM MENU.
2
Press 9 repeatedly to select SETUP VIDEO OUTPUT, then
press OK.
3
Press 9 to select VIDEO OUTPUT, then press -.
4
Press 9 or 8 to select S-VIDEO or YCBCR, then press OK.
Choose S-VIDEO if you connected the Player’s S-VIDEO (VIDEO
OUT) jack to the TV’s S-Video In jack as described on page 11.
Choose YCBCR if you connected the Player’s Y CB CR (VIDEO
OUT) jacks to your TV’s Component Video In jacks as described on
page 12.
5
Press SYSTEM MENU to remove the menus.
1,5
2-4
- - VIDEO OUTPUT PAGE - -
VIDEO OUTPUT YCBCR
TV DISPLAY
VIDEO OUTPUT
F
S-VIDEO
TV TYPE YCBCR
VIDEO MODE
BRIGHTNESS
CONTRAST
SATURATION
1