Filter
Top Products
English
60
Setup Menu Options (continued)
Setup settings (These settings will be taken from the rst installation)
Auto Install Press OK on the remote control to start the automatic TV channel
search process and replace all previously stored analogue TV channels.
This process may take several minutes.
Manual Search In some cases, not all of the available TV channels may have been found
and stored during rst installation. In this case, you will need to search for
and store the missing or coded TV channels manually. Press OK to access
the submenus.
Use keys to select the options in the menu and press OK to
con rm. Press to go back to the previous menu and press
SETUP to save and exit.
{ Channel/Freq. } – Select manual search based on channel
allocation or frequency (Programme, FREQ,
S. Channel).
Note: S. Channel (Special channel) refers to
speci ed hyperband channels.
{ Entry/Search } – Use the numeric keypad 0-9 to enter the
channel number of the TV programme or
start manual frequency search and press OK
to con rm.
{ Program # } – Use the numeric keypad 0-9 to enter the
programme number for the channel to store
(e.g., ‘01’) and press OK to con rm.
{ Channel Name } – Use the keys to select the channel name
and press OK to con rm.
Note: Move to { Channel Name } and press
to go to the next page
or move to { Decoder } and press back to the previous page.
{ Decoder } – If the current TV channel is transmitted by
coded TV signals that can only be viewed
properly with a decoder which is connected
to the EXT2 AUX-I/O socket, you need to
activate the connected decoder.
{ On } – Select this to allocate the connected
decoder to this TV channel.
{ Off } – Turn off the decoder feature.
{ TV System } – Set the TV system that produces the least
distortion of picture and sound. See last page
“TV System Guide” for more information.
{ NICAM } – NICAM is a digital sound transmission system.
It can transmit either one stereo channel or
two separate mono channels.
{ On } – Select this to improve the sound
transmission of the TV channel.
{ Off } – Select this if the reception is poor
and the sound is distorted.
{ Fine Tuning } – Select this to ne-tune the TV channel manually
if the reception is poor. Use keys to adjust
the frequency and press OK to con rm.
Manual Channel Search (Page 1)
Channel/Freq.
Entry/Search
Program #
Channel Name
Channel
000
1
-----
"OK to Select. NEXT to Page 2"
Press SETUP to save and exit
Manual Channel Search (Page 2)
Decoder
TV System
NICAM
Fine Tuning
Off
On
Press Previous for page 1 of options
Press SETUP to save and exit
dvdr3300H_eu_eng_17223d.indd 60dvdr3300H_eu_eng_17223d.indd 60 2005-10-19 4:16:43 PM2005-10-19 4:16:43 PM