Filter
Top Products
/05_8239 210 98393
14
Selecting the colour system that
corresponds to your TV
This DVD Player is compatible with both
NTSC and PAL. In order for a DVD disc
to play on this Player, the colour system of
the Disc, the TV and the DVD Player
should match.
1 Press SYSTEM MENU.
2 Press 4 3 to select ‘Video Setup Page’.
3 Enter its submenu by pressing OK.
4 Use the 1 2 3 4 keys on the Remote
Control to navigate in the menu.
Move to ‘TV Standard’ and press B.
Getting Started
- - VIDEO SETUP PAGE - -
TV STANDARD
TV DISPLAY
CLOSED CAPTIONS
VIDEO OUTPUT
PROGRESSIVE
SMART PICTURE
MULTI
NTSC
PAL
MAIN PAGE
To deactivate Progressive manually
- cont’d
If the progressive function is activated, but
your TV does not support progressive
function or YPbPr cable is not connected
accordingly, there will be a blank screen.
You can deactivated progressive function
as below:
1 Press STANDBY ON on the front panel
to switch on the DVD player.
2 Press OPEN/CLOSE on the front panel
to open the disc tray.
3 Press numerical key pad ‘1’.
➜ The blue Philips DVD background
appears on the TV screen.
PAL – Select this if the connected TV is
PAL system. It will change the video signal
of a NTSC disc and output in PAL format.
NTSC – Select this if the connected TV
is NTSC system. It will change the video
signal of a PAL disc (VCD only) and
output in NTSC format.
Multi – Select this if the connected TV is
compatible with both NTSC and PAL
(multi-system). The output format will be
in accordance with the video signal of the
disc.
Helpful Hints:
– Before changing the current TV
Standard setting, ensure that your TV
supports the ‘selected TV Standard’
system.
– If there is no proper picture on
your TV, wait for 15 seconds for auto
recovery.
- - REFER TO THE OWNER'S MANUAL - -
Changing MULTI to PAL
1. Ensure your TV supports PAL
2. If there is a blank screen on normal TV
wait 15 seconds for auto recover
CANCEL
OK
1 2 - Move OK - Select
- - REFER TO THE OWNER'S MANUAL - -
Confirm again to use PAL
If picture is good, press OK button on remote control
CANCEL
OK
1 2
- Move OK - Select
TO GO BACK TO MULTI
1. Open tray,
2. Press '3' Key
.
To exit from the menu
Press SYSTEM MENU.
01-36 DVP630_EU_051 18/03/2004, 10:04 AM14