Filter
Top Products
8 Installation
Factory settings
This function allows you to reset most of the picture and sound settings to
their predefined factory values.
& Select Factory settings with the cursor down.
é Press OK to erase settings and reset them to their default values.
OSD (On Screen Display)
& Select OSD with the cursor down.
é Press the cursor right to select Normal or Minimum.
Normal to activate extended display of TV channel and programme
information on screen.
Minimum to activate the display of reduced channel information.
See Use of the Remote Control, p. 10, i On screen information.
Note:When Subtitles is switched on, see Features, p. 16, display of the
programme number is not possible.
Programme title
& Select Programme title with the cursor down.
é Press the cursor right to select Programme title Yes or No.
When selected
Ye s, after the selection of a TV programme or after pressing
the i key on the remote control, a TV channel which broadcasts teletext
may transmit the name of the TV channel or the programme title.
When selected
No, the programme title will only appear after pressing the
i key, and not after the selection of a TV channel.
Set/Change code
The Child lock feature (see TV, Features, p. 16) allows you to lock channels to
prevent children from watching certain programmes.
To watch locked channels, you need to enter an access code.
The Set/Change code menu item allows you to create or change a Personal
Identification Number (PIN).
& Select Set/Change code with the cursor down.
é If no code exists yet, the menu item is set to Set code.Follow the
instructions on screen.
If a code has previously been entered, the menu item is set to
Change code.
Follow the instructions on screen.
All number combinations from 0000 to 9999 are valid numbers.
“ The General menu reappears with a message confirming that the code has
been created.
Important:You have forgotten your code !
& Select Set/Change code in the General menu.
é Press OK.
“ Press the cursor right.
‘ Enter the overriding code 8-8-8-8.
( Press the cursor again and enter a new personal 4-digit code.
The previous code is erased and the new code is stored.
General
OSD
Setup
Normal / Minimum
General
Programme title
Setup
Yes / No
General
Set/Change code
Setup
1003.5 en 04-03-2003 09:13 Pagina 8