Filter
Top Products
21
English
Tuning to radio stations
1 Press STANDBY ON to switch on the last selected
source.
2 Adjust SOURCE (or press TUNER) to select TUNER
mode.
3 Press TUNER again to select the desired band : FM, MW
or LW.
4 Press and hold S or T until the frequency indication
starts to change, then release.
➜ The system automatically tunes to the next strong radio
station.
● To tune to a weak station, press S or T briefly and
repeatedly until an optimal reception is found.
5 Repeat step 4 if necessary until you find the desired radio
station.
Presetting radio stations
You can preset up to 40 stations regardless of the
reception.
1 Tune to your desired radio station (refer to “Tuning to radio
stations”).
2 Press PROGRAM.
➜ “Program” appears.
Program
3 Use the numeric keypad (0-9) to select the desired
preset number.
Program
Note:
– If “Program” icon goes off before you select the desired
preset number, press PROGRAM again.
4 Press PROGRAM again to store the radio station.
● Repeat steps 1–4 to store other radio stations.
Notes:
– If you attempt to programme more than 40 preset radio
stations, "FULL" is displayed.
– During programming, if no key is pressed within five
seconds, the system will exit the programme mode
automatically.
Listening to preset radio
stations
● In tuner mode, press 1 or 2 or use the numeric keypad
(0-9) to select the desired preset number.
➜ The preset number, radio frequency, and waveband are
displayed.
Sleep timer setting
The sleep timer enables the system to switch to standby
mode automatically at a preset time.
1 Press SLEEP repeatedly to select a preset time.
➜ The selections are as follows (time in minutes):
15 ™ 30 ™ 45 ™ 60 ™ 90 ™ 120™ OFF ™ 15...
2 When you reach the desired length of time, stop pressing
the SLEEP button.
➜ “Sleep” icon appears.
To check the remaining length of time after sleep
timer is activated
● Press SLEEP once.
To change the preset sleep timer
● Press SLEEP again while the remaining sleep timer is
shown.
➜ The display will show the next sleep timer options.
To deactivate the sleep timer
● Press SLEEP repeatedly until "OFF" is displayed, or press
the STANDBY ON button.
Other Functions
OTHER FUNCTIONS
pg 001-023/LX3xxx/22-Eng 4/16/02, 1:22 PM21