Filter
Top Products
27
English
Clock/Timer
Timer setting
The system can switch on to DISC or TUNER mode
automatically at a preset time, serving as an alarm to wake
you up.
IMPORTANT!
– Before setting the timer, ensure that the clock
is set correctly.
– The timer will always be switched on after it
has been set.
– The volume of the timer will increase gradually
to minimum level 12 or the last tuned volume
level.
1 Hold down CLOCK•TIMER for more than two
seconds to enter timer mode.
➜ The clock timer and starts flashing.
2 Press SOURCE repeatedly (or DISC or TUNER on the
remote control) to select the sound source.
➜ “DISC XX:XX" indicates the disc mode is selected.
➜ “TUNER XX:XX” indicates the Tuner mode is selected.
3 Press S or T to set the hours and minutes. To
increase the speed, hold down S or T.
4 Press CLOCK•TIMER to store the timer.
➜ The set timer "XX:XX" and the selected source are
displayed.
➜ remains on the display.
● At the preset time, the selected sound source will play.
➜ If DISC source is selected, the timer will wake up by
playing the first track of the disc or programmed track. If
the disc tray is empty, it will switch to Tuner mode.
➜ If Tuner source is selected, the timer will wake up by
playing the last tuned radio station.
Note:
– During timer setting, if no button is pressed within 90
seconds, the system will exit timer setting mode automatically.
CLOCK/TIMER
Deactivating the timer
1 Hold down CLOCK•TIMER for more than two
seconds to enter timer mode.
2 In timer mode, press Ç on the system to cancel the timer.
➜ disappears from the display and "TIMER OFF" is
displayed.
Activating the timer to the last preset
time and source
1 Hold down CLOCK•TIMER for more than two
seconds to enter timer mode.
2 Press CLOCK•TIMER again to store the timer setting.
➜ The last set timer information is displayed for a few
seconds and is shown.
Sleep timer setting
The sleep timer enables the system to switch to standby
mode automatically at a preset time.
1 Press SLEEP on the remote control repeatedly to select a
preset amount of time after which the system will shut itself
off automatically.
➜ The selections are as follows (time in minutes):
15 ™ 30 ™ 45 ™ 60 ™ 90 ™ 120 ™ OFF ™ 15 …
➜ "SLEEP XX" or "SLEEP OFF" is displayed. "XX" is the
time in minutes.
2 When you reach the desired length of time, stop pressing
the SLEEP button.
➜ The sleep timer is now set. Before the system switches
to standby mode, a countdown of 10 seconds is displayed.
"SLEEP 10" ™ "SLEEP 9".... ™ "SLEEP 1"
™ "SLEEP"
To check the remaining length of time after
sleep timer is activated
● Press SLEEP once.
To change the preset sleep timer
● Press SLEEP again while the remaining sleep timer is
shown.
➜ The display will show the sleep timer options.
To deactivate the sleep timer
● Press SLEEP repeatedly until "SLEEP OFF" is displayed,
or press the STANDBY ON button.