Filter
Top Products
15
English
Basic Operations
IMPORTANT!
– Before you operate the system,
complete the connection procedures.
– When the system is switched to Standby
mode, it is still consuming power.To
disconnect the system from the power
supply completely, remove the AC power
plug from the wall socket.
Switching the system on/off
● Press STANDBY ONB (B on the remote).
➜ B lamp on the front panel will light off, and
the system’s display information will be displayed.
● Press DISC, or AUX on the remote (or
SOURCE on the system).
➜ The system will switch to the selected source.
To switch the system to standby mode
● Press STANDBY ONB (B on the remote).
➜ B lamp on the front panel will light up, and
the system’s display information will be turned
off.
Power saving automatic standby
As a power-saving feature, the system will
automatically switch to Standby mode if you
don’t press any button within 30 minutes in the
stop mode.
Volume control
Press VOLUME (+/-) (or VOL +/- on the
remote) to increase or decrease the volume
level.
➜ The display briefly shows ”VOL” and a volume
value from “01” to “39” ( “MIN” or “MAX” is
displayed when adjusted to the lowest or highest
volume level).
To switch off the volume temporarily
● Press MUTE on the remote.
➜ Playback will continue without sound and
“MUTE” is displayed briefly.
● To activate sound reproduction, you can:
– press MUTE again;
– adjust the volume controls;
– change source.
Sound Control
DBB (Dynamic Bass Boost)
DBB enhances the bass response.
● Press DBB to enable or disable DBB feature.
➜ If DBB is activated, “DBB” will be shown.
Helpful hints:
– Some discs might be recorded in high
modulation, which causes a distortion at high
volume. If this occurs, switch off DBB or reduce the
volume.
DSC (Digital Sound Control)
DSC provides a different type of preset sound
equalizer setting.
● Press DSC on the remote (or on the system)
repeatedly to select:
CLASSIC, POP, ROCK or JAZZ
➜ The display shows the selected sound setting.
pg 001-030-mcd109_55_Eng 24/8/06, 14:2915