Filter
Top Products
18
English
IMPORTANT!
– Make sure to complete the
preparation procedures before operating
the system.
Before using the remote control
1 Pull out the plastic protective sheet.
2 Select the source you wish to control by pressing
one of the source select keys on the remote
control (for example DISC, TUNER).
3 Then select the desired function (for example
ÉÅ , à , á).
Replacing battery (lithium
CR2025) into the remote control
1 Press the slot on the battery compartment.
2 Pull out the battery compartment.
3 Replace a new battery and fully insert the
battery compartment back to the original
position.
1
2
3
CR2025
CAUTION!
Batteries contain chemical substances, so
they should be disposed of properly.
Preparations
Step 2: Setting the clock
1 Go to Standby mode.
2 Press and hold DISPLAY/CLOCK on the
remote control.
➜ "SET CLOCK" is displayed briefly. Then, the
hour digits flash on the display screen.
3 Press VOLUME +/- on the front panel or VOL
+/- on the remote to set the hours.
4 Press DISPLAY/CLOCK again.
➜ The minute digits flash on the display screen.
5 Press VOLUME +/- on the front panel or VOL
+/- on the remote to set the minutes.
6 Press DISPLAY/CLOCK to confirm the clock
setting.
Notes:
– The clock setting will be erased when the system
is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 20 seconds.
Remove the plastic protective sheet
pg001-pg035_MCD119-12-Eng 2007.8.13, 11:0618