Filter
Top Products
14
English
Using an accessory RF modulator
IMPORTANT!
– If your TV set only has a single
Antenna In jack (or labelled as 75 ohm or
RF In), you will need a RF modulator in
order to view the DVD playback via TV.
See your electronics retailer or contact
Philips for details on RF modulator
availability and operations.
1 Use the composite cable (yellow) to connect the
system's VIDEO jack to the video input jack on
the RF modulator.
2 Use an RF coaxial cable (not supplied) to
connect the RF modulator to your TV's RF jack.
Connections
Using component Video In jack (Pr Pb Y)
● Use the component video cables (red/blue/
green, not supplied) to connect the system’s PR/
PB/ Y jacks to the corresponding Component
video input jacks (or labeled as Pr/Cr Pb/Cb Y or
YUV) on the TV set.
● To listen to TV channels through this system, use
the audio cables (white/red) to connect AUX
IN (L/R) jacks to the corresponding AUDIO
OUT jacks on the TV set.
1.000
Using Scart jack
1 Use the scart cable (not supplied) to connect
the system’s TV SCART OUT jack to the
corresponding SCART input jacks on the TV set.
1.000
TO TV
TO TV
2 To listen to TV channels through this system, use
the scart cable (not supplied) to connect the
system’s TV SCART OUT jack to the
corresponding SCART output jack on the TV set.
● Before starting operation, press AUX on the
remote control to select “AUX” in order to
activate the input source. The music will be heard
through the speakers.
1.000
AUDIO IN
R L
VIDEO
IN
TO TVANT IN
CH3 CH4
RF coaxial cable to TV
Back of RF Modulator
(example only)
Antenna or
Cable TV signal
pg001-pg039_MCD149-12-Eng 2007.9.13, 15:3514