Philips MCD295/05 DVD Player User Manual


 
18
English
Preparations
IMPORTANT!
Make sure to complete the
preparation procedures before operating
the system.
Step 1: Inserting batteries into
the remote control
1 Open the battery compartment.
2 Place two batteries (Type R06 or AA) in the
compartment with the correct polarity as
indicated by “+” and “–” symbols.
3 Close the cover.
Using the remote control to operate the
system
1 Point the remote control directly
at the remote sensor (iR) on the
front panel.
2 Select the source you wish to
control by pressing one of the
source select buttons on the
remote control (for example
DISC, TUNER).
3 Then select the desired function
(for example 2;, í, ë).
CAUTION!
Remove batteries if they are
exhausted or will not be used for a long
time.
Do not use old and new or different
types of batteries in combination.
Batteries contain chemical substances,
so they should be disposed of properly.
Step 2: Setting the clock
1 Go to Standby mode.
2 Press and hold CLOCK/RDS on the front
panel.
SET CLOCKis displayed briefly. Then, the
hour digits flash on the display screen.
3 Turn the VOLUME control on the front panel
or press VOLUME +/- on the remote to set
the hours.
4 Press CLOCK/RDS again.
The minute digits flash on the display screen.
5 Turn the VOLUME control on the front panel
or press VOLUME +/- on the remote to set
the minutes.
6 Press CLOCK/RDS to confirm the clock
setting.
Notes:
This system only supports 24-hour mode.
The clock setting will be erased when the system
is disconnected from the power supply.
The system will exit clock setting mode if no
button is pressed within 30 seconds.
pg001-pg040_MCD295-05-Eng 2006.3.24, 17:2718