Filter
Top Products
73
English
Tuner
Tuning to radio stations
1 Press STANDBY-ONy (or y on the remote)
to switch on the last selected source.
2 Press repeatedly SOURCE (or TUNER on the
remote) until FM or MW is displayed.
3 Press and hold TUNING 34 or TU +/- à /
á on the remote until the frequency in the
display starts changing.
➜ Display shows SEARC during automatic
tuning.
➜ After the system tunes to a station of
sufficient reception, display shows its frequency .
● To tune to a weak station, press briefly and
repeatedly TUNING 34 or TU +/- à / á
on the remote until an optimal reception is
found.
4 Repeat Step 3 if necessary until you find the
desired radio station.
Storing preset radio stations
You can preset up to 40 stations (20 in each
band) regardless of the reception.
Manual programmng
1 Tune to your desired radio station (refer to
“Tuning to radio stations”).
2 Press PROG on the remote.
➜ ”PROG” icon flashes.
3 Press PRESET3/4 or CH +/- (¡ / ™) on the
remote to select the desired preset number.
4 Press PROG on the remote again to store the
radio station.
➜ ”PROG” disappears on the display.
● Repeat steps 1-4 to store other radio stations.
Helpful hints:
–You can erase a preset station by storing
another frequency in its place.
Autostore: automatic programming
Autostore automatically starts programming
radio stations from preset 1. Any previous
presets e.g. manually programmed will be erased.
● In tuner mode (FM or AM), press and hold
PROG until AUTO appears.
➜ During automatic programming, display shows
AUTO and flashing PROG.
➜ Available stations are programmed (20FM or
20 AM).
➜ After all stations are stored, the first autostore
preset station automatically plays.
Listening to preset radio stations
● In tuner mode, press PRESET3/4 or CH +/-
(¡ / ™) on the remote to select the desired
preset number.
➜ The preset number, radio frequency, and
waveband are displayed.
pg042-079_MCD305_93-Eng 2005.11.18, 16:4873