Filter
Top Products
36
English
Clock/Timer
Clock setting
See "Preparations-Step 2: Setting the clock".
Timer setting
● The system can be used as an alarm clock,
whereby the selected source (DISC, TUNER or
USB) starts playback at a preset time. Make
sure the clock is set before using the
timer.
1 In standby mode, press and hold SLEEP/
TIMER on the remote control until appears.
➜ SELECT SOURCE displays.
2 Press SOURCE on the set repeatedly to select
the source (or press DISC, TUNER or USB
on the remote control).
3 Press SLEEP/TIMER to confirm.
➜ The hours digits start flashing.
4 Tu rn the VOL control on the front panel or
press VOL +/- on the remote to set the hours
and press SLEEP/TIMER to confirm.
➜ The minute digits flash on the display panel.
5 Tu rn the VOL control on the front panel or
press VOL +/- on the remote to set the minutes
and press SLEEP/TIMER to confirm.
Activating and deactivating
TIMER
● In standby mode, press SLEEP/TIMER on the
remote once or more to activate or deactivate
the timer.
➜ Display shows if activated, and disappears
if deactivated.
Sleep timer setting
The sleep timer enables the system to switch off
by itself after a set period of time.
1 In active mode, press SLEEP/TIMER on the
remote control repeatedly to select a preset
time.
➜ The selections are as follows (time in
minutes):
SLEEP OFF ™ SLEEP 10 ™ SLEEP 20 ™
SLEEP 30 ™ SLEEP 40 ™ SLEEP 50 ™
SLEEP 60 ™ SLEEP 70 ™ SLEEP 80 ™
SLEEP 90™ SLEEP OFF
2 When you reach the desired length of time, stop
pressing the SLEEP/TIMER button.
To deactivate the sleep timer
● Press SLEEP/TIMER repeatedly until "SLEEP
OFF" is displayed, or press ECO POWER/
STANDBY ON y (or y on the remote).
USB
pg001-pg041_MCD395-Eng 2010.4.2, 12:4736