Filter
Top Products
37
English
Clock/Timer
Clock setting
See "Preparations-Step 2: Setting the clock".
Timer setting
● The system can be used as an alarm clock,
whereby the last selected source is switched on
at a set time (one time operation). The clock
time needs to be set first before the timer can
be used.
1 In standby mode, press and hold TIMER SET3
(TIMER on the remote) for more than three
seconds.
➜ "SET TIMER" is displayed briefly. Then, the
hour digits flash on the display panel.
2 Turn the VOLUME control on the front panel
or press VOL +/- on the remote to set the
hours and press TIMER SET3 (TIMER on
the remote) to confirm.
➜ The minute digits flash on the display panel.
3 Turn the VOLUME control on the front panel
or press VOL +/- on the remote to set the
minutes and press TIMER SET3 (TIMER on
the remote) to confirm.
➜ "ON" or "OFF" flashes.
4 Tu rn the VOLUME control on the front panel
or press VOL +/- on the remote to activate or
deactivate the timer and press TIMER SET3
(TIMER on the remote) to complete the
setting.
➜ Display shows if activated, and disappears
if deactivated.
Sleep timer setting
The sleep timer enables the system to switch off
by itself after a set period of time.
1 Press SLEEP on the remote control repeatedly
to select a preset time.
➜ The selections are as follows (time in
minutes):
0FF ™ 10 ™ 20 ™ 30 ™ 40 ™ 50 ™ 60 ™
70 ™ 80 ™ 90™ 0FF
➜ "SLEEP XX" is displayed. "XX" is the time in
minutes.
2 When you reach the desired length of time, stop
pressing the SLEEP button.
To deactivate the sleep timer
● Press SLEEP repeatedly until "0FF" is displayed,
or press ECO POWER/STANDBY ON y.
THEATHRE
5
TUNING
PRESET
DSC
PROGRAMMODEANGLE A-B
IS
pg001-pg042_MCD515-37-Eng 2006.2.27, 16:2137