Filter
Top Products
12
English
Step 3: Connecting the control
cable
● Connect the serial port marked “CONTROL
CABLE” at the rear of the DVD player to the
same port at the rear of the power amplifier
with the supplied flat control cable.
Step 4: Connecting TV
IMPORTANT!
–You only need to make one video
connection from the following options,
depending on the capabilities of your TV.
– Connect the DVD system directly to
the TV.
–A SCART connection allows you to
use features both Audio and Video
features on the DVD Player.
Using SCART jack
AUDIO
IN
S-VIDEO
IN
VIDEO IN
TV IN
AUDIO
IN
S-VIDEO
IN
VIDEO IN
TV IN
● Use the SCART cable (black) to connect the
DVD Player’s SCART jack to the corresponding
Scart input jacks on the TV (cable not supplied).
Note:
– Ensure that the “TV” indication on SCART cable
is connected to the TV set and “DVD” indication on
SCART cable is connected to the DVD Player.
Connections
Step 2: Connecting speakers
● Connect the left and right speakers to the
SPEAKERS (4Ω) terminals on the back of the
power amplifier with the supplied speaker cables.
Right speaker to “R” and left speaker to “L”, red
wire to “+” and black wire to “-”. Fully insert the
stripped portion of the speaker wire into the
terminal as shown.
1
2
3
Speaker wire connection on main set
12
Speaker wire connection on speakers
Notes:
– Ensure that the speaker cables are correctly
connected. Improper connections may damage the
system due to short-circuit.
–For optimal sound performance, use the
supplied speakers.
– Do not connect more than one speaker to any
one pair of +/- speaker jacks.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
pg 001-024_MCD908_Eng-12 2007.6.12, 16:3312