Filter
Top Products
English
23
Switching the system on/off
● Press ECO POWER/STANDBY-ONB (B
on the remote).
➜ A countdown of 10 seconds starts for
preheating of the systme. Then, the system will
switch to the last selected source.
● Press DISC, TUNER or AUX on the remote.
➜ The system will switch to the selected source.
To switch the system to standby mode
● Press ECO POWER/STANDBY-ONB (B
on the remote).
➜ “BYE BYE” is displayed briefly.
Switching the system to Eco
Power Standby mode
● Press ECO POWER/STANDBY-ON B in
active mode.
➜ The system enters Eco power standby (the
ECO POWER LED is on) or normal standby
mode with clock display.
● The volume level (up to a maximum volume
level of 12), interactive sound settings, last
selected mode, source and tuner presets will be
retained in the player's memory.
● If the system is in normal standby mode with
clock display, press and hold ECO POWER/
STANDBY-ON B for 3 seconds or more to
switch to Eco power standby or vice versa.
Power-saving automatic standby
As a power-saving feature, the system will
automatically switch to Standby mode if you do
not press any buttons within 15 minutes after a
disc has stopped playing.
Volume control
Tur n VOLUME (-/+) clockwise or anticlockwise
(or press VOLUME +/- on the remote) to
increase or decrease the volume level.
➜ ”VOL XX” is displayed on the display panel.
“XX” denotes the volume level.
To switch off the volume temporarily
● Press MUTE on the remote.
➜ Playback will continue without sound and
“MUTING” flashes.
● To activate sound reproduction, you can:
– press MUTE again;
– adjust the volume controls;
– change source.
Sound control
BASS, TREBLE and LOUDNESS sound
features cannot be activated at the same
time.
Bass enhancement
Bass adjustment enhances the bass response.
● Press BASS +/- on the remote repeatedly to
adjust the bass level.
➜ Some discs might be recorded in high
modulation, which causes a distortion at high
volume. If this occurs, switch off DBB or reduce
the volume.
Treble adjustment
The treble (high tone) setting enables you to
adjust the treble level of the system.
● Press TREBLE +/- on the remote control
repeatedly adjust the treble level.
LOUDNESS
LOUDNESS feature enables the system to
automatically increase the treble and bass sound
effect at low volume (the higher the volume, the
lower the treble and bass increase).
● Press LOUDNESS on the remote to enable or
disable LOUDNESS feature.
➜ icon appears/disappears after this feature
is enabled/disabled.
Basic Operations
pg 001-024_MCD908_Eng-12 2007.6.12, 16:3323