Filter
Top Products
If you connected the DVD Player to a Stereo using the COAXIAL jack as
shown on page 15, you need to adjust the DIGITAL OUTPUT (audio)
setting as described below. If you are not using the COAXIAL jack, no
adjustment is necessary.
1
Press SYSTEM MENU.
2
Press 2 to select the AUDIO SETUP PAGE icon at the top
of the menu. Press OK or 4.
3
Press 4 to select DIGITAL AUDIO SETUP, then press OK.
4
DIGITAL OUTPUT will be highlighted in green. Press 2.
5
Press
3
or
4
to select ALL or PCM ONLY, then press OK.
Your selection will be highlighted in brown.
Choose ALL to select the original default audio settings as received
by most Stereos. However, if the sound is distorted, your Stereo may
need to receive audio in the PCM format (pulse code modulation,
contains only left and right audio signals).
Choose PCM only if your Stereo is PCM-compatible. Or, if your
Stereo cannot decode MEG-2 or DTS audio, choose PCM only.
Refer to your Stereo owner’s manual for details.
6
Press SYSTEM MENU to remove the menus.
40 Digital Output
1,6
2-5