Filter
Top Products
Hookups (cont’d) 15
Connecting to a TV and a Stereo
(Stereo has Dolby
®
Digital or MPEG2)
Back of TV
(example only)
COAXIAL DIGITAL
AUDIO IN
2
1
Stereo Receiver
(example only)
VIDEO IN
VIDEO IN
3
1
Connect the COAXIAL jack of the DVD Player to the
COAXIAL DIGITAL AUDIO IN jack on your Stereo. Use an
appropriate digital audio cable (not supplied). See your electronics
retailer for details and availability.
2
Connect the supplied video cable to the yellow VIDEO
(VIDEO OUT) jack of the DVD Player and to the TV’s
VIDEO IN jack. The supplied video cable has yellow markings.
3
Plug the power cords of the DVD Player, Stereo, and TV
into an active power outlet. Press STANDBY-ON
yy
on the
front of the DVD Player to turn it on.
4
Turn on the Stereo and set it to the correct Audio In
channel or sound source. Refer to the Stereo owner’s manual for
details.
5
Turn on the TV. Set it to the correct Video In channel. See
your TV owner’s manual for details. Or, go to your lowest TV
channel (01 or 02) and change channels downward until you see the
blue DVD screen saver on the TV.
• Set DIGITAL OUTPUT and
LPCM OUTPUT accordingly.
Details are on page 40.
• Your Stereo must support
MPEG2 or Dolby
®
Digital.
Check the Stereo’s manual.
• If you prefer or need to use the
S-VIDEO or Y Pb Pr jacks
instead, see pages 12-13.
Helpful Hints