Filter
Top Products
<
5 Unscrew screws B.
6 Grasp the lamp holder handle and carefully pull the lamp holder out of the projector.
• Do not tilt. If the inner tube is broken glass particles may fall out.
• Keep lamp holder opening to your right. Do not touch lamp or point lamp holder opening
at anyone.
7 Carefully remove the new lamp housing from its package.
• Always use the same type of lamp: LCA3122/00 (150 W), 12nc: 8670 931 22009.
• Do not touch lamp or point lamp housing opening at anyone.
• Do not drop, as the impact may cause the lamp to break.
8 Place the lamp holder in the guiding slots and insert into the lamp compartment.
9 Tighten screws B again.
10 Put the lamp door back in place, using a screwdriver.
– The Mains inlet socket will open again.
11 Insert the mains lead into both the projector Mains inlet socket and the wall socket.
12 Press the Standby button to switch on the projector.
13 Reset the lamp life time (see ‘Resetting the lamplife time’).
14 Dispose of the old lamp in special chemical disposal bins.
1 Press Menu.
– The menu bar appears on the screen.
2 Use Cursor Control to select ‘Lamp counter’ in the ‘Set up’ menu.
4 Press OK for 10 seconds to reset the lamp counter.
5 If required, select another item you wish to adjust or press Menu to exit.
Resetting the lamplife
time
Philips Multimedia Projector 33 English User guide bClever SV1
6. Maintenance
B
B
B
B
B
S-VIDEO
DATA
VIDEO
PICTURE SIZE – PICTURE SIZE +
VOLUME +
VOLUME –
SOURCE
MENU OK
PICTURE SIZE – PICTURE SIZE +
VOLUME +
VOLUME –
SOURCE
AV MUTE
MENU OK
STANDBY
OKMENU
MUTE
ZOOM
VIDEO
FREEZE
STAND BY
S-VIDEO
COLOUR TRACKING
CONTRASTBRIGHTNESS
DATA
PICTURE SIZE
PICTURE FORMAT
AV MUTE
INFO
KEYSTONE
KEY LOCK